Servicios Personalizados
Revista
Articulo
Indicadores
- Citado por SciELO
- Accesos
Links relacionados
- Similares en SciELO
Compartir
Revista Técnica energía
versión On-line ISSN 2602-8492versión impresa ISSN 1390-5074
Resumen
POZO, Adrián; AYALA, Edy; SIMANI, Silvio y MUNOZ, Eduardo. Indirect Speed Control Strategy for Maximum Power Point Tracking of the DFIG Wind Turbine System. Revista Técnica energía [online]. 2021, vol.17, n.2, pp.92-101. ISSN 2602-8492. https://doi.org/10.37116/revistaenergia.v17.n2.2021.426.
In this In this article, a control strategy for Maximum Power Point Tracking (MPPT) of a wind turbine system based on a Doubly Fed Induction Generator (DFIG) is presented. The proposed strategy consists of the Indirect Speed Control (ISC) taking the Low Speed Shaft (LSS) as variable input. This implementation allows the MPPT to optimize the Power coefficient (Cp). The controller has been designed in order to allow the wind turbine to reach the MPPT along the partial load operation. For these experiments, a 1.5 MW wind turbine was modeled and simulated by using Matlab and Fatigue, Aerodynamic, Structure and Turbulence (FAST) software. In order to present the achieved results, a comparison between the ISC and a classical PI controller is made. The Cp curves as well as the output power display an important improvement in terms of stability. These results are possible because the appropriate values of optimal Tip Speed Ratio (TSR) and maximum Cp have been properly established. article, a control strategy for Maximum Power Point Tracking (MPPT) of a wind turbine system based on a Doubly Fed Induction Generator (DFIG) is presented. The proposed strategy consists of the Indirect Speed Control (ISC) taking the Low Speed Shaft (LSS) as variable input. This implementation allows the MPPT to optimize the Power coefficient (Cp). The controller has been designed in order to allow the wind turbine to reach the MPPT along the partial load operation. For these experiments, a 1.5 MW wind turbine was modeled and simulated by using Matlab and Fatigue, Aerodynamic, Structure and Turbulence (FAST) software. In order to present the achieved results, a comparison between the ISC and a classical PI controller is made. The Cp curves as well as the output power display an important improvement in terms of stability. These results are possible because the appropriate values of optimal Tip Speed Ratio (TSR) and maximum Cp have been properly established.
Palabras clave : Power Coefficient; MPPT; Indirect Speed Control; DFIG; Wind Turbine..