Serviços Personalizados
Journal
Artigo
Indicadores
- Citado por SciELO
- Acessos
Links relacionados
- Similares em SciELO
Compartilhar
FIGEMPA: Investigación y Desarrollo
versão On-line ISSN 2602-8484versão impressa ISSN 1390-7042
Resumo
CALDERON FREIRE, Edisson Fernando; TORRES GALLEGOS, Luis e ORTEGA ESPIN, Andrés. Fabricación de material biodegradable a base de polímeros termoplásticos combinados con fibras cortas de lino. Figempa [online]. 2019, vol.7, n.1, pp.32-38. ISSN 2602-8484. https://doi.org/10.29166/revfigurav1i1.1402.
The present study analyzes the characteristics and the parameters necessary for the manufacture of a biodegradable composite material through the processes of extrusion, crushing and injection in order to optimize the mechanical properties of the composite material obtained. The thermoplastic polymers used as polymer matrix are polylactic acid (PLA), Poly (3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) and a thermoplastic with starch base. Also, short flax fiber was used as reinforcement, with a length less than 3mm in length. The process of obtaining the composite material begins with the transformation of the biopolymer mixture combined with flax fiber, in a twin screw extruder for thermoplastics, where a filament of bio-composite material is obtained, which is crushed to obtain granulated material or pellets; the next process has been to transform the pellets of the composite material, by injection, into rectangular sheets with dimensions of 180 x 200 mm and thickness of 2.5 mm. To process the material in the mixing screw of the extruder, the melting temperature of the material must be maintained according to the study carried out in the differential scanning calorimetry tests. The differential scanning calorimetry (DSC), shows a range of temperatures where heat flow peaks occur, this test consists in progressively raising the temperature of the material and comparing the exothermic or endothermic processes present in the material, with this test they are obtained the glass transition, melting and degradation temperatures of the thermoplastic matrix, the appropriate handling values were: PLA (167.16 ° C), PHBV (178.62 ° C) and Starch Compound (142.71 ° C) , the parameters of temperature and pressure of injection are determined, these variables are essential to guarantee the manufacture of the different samples of composite material and in later stages destructive tests are carried out to examine the result in the mechanical properties of the biodegradable composite material.
Palavras-chave : PLA; PHBV; extrusion; injection; biocomposite.