11 3 
Home Page  

  • SciELO

  • SciELO


Enfoque UTE

 ISSN 1390-6542 ISSN 1390-9363

PEREZ-SALINAS, Cristian; RIERA, Marilyn    TONATO, Carlos. Estudio experimental sobre el corte con láser de CO2 a baja potencia, del compuesto de plástico reforzado con fibras naturales. []. , 11, 3, pp.55-68. ISSN 1390-6542.  https://doi.org/10.29019/enfoque.v11n3.572.

^a

La aplicación de los plásticos reforzados con fibras naturales en la industria puede aumentar mediante el uso de tecnologías más rápidas y flexibles, como el corte por láser. La naturaleza anisotrópica y el grado de combustión de las fibras naturales en este tipo de compuestos hacen que el procesamiento con láser sea muy desafiante. Este estudio trata sobre el rendimiento de corte de un láser de CO. a baja potencia, para cortar placas de compuestos poliméricos (matriz de resina poliéster y epoxi), reforzado con fibras naturales (abacá y cascarilla de arroz), de 3 mm de espesor promedio. Se empleó un diseño experimental DOE y un análisis de varianza Anova para determinar los parámetros significativos e influyentes en la calidad de corte y el efecto térmico en el material. Los parámetros de procesamiento fueron la potencia de corte, velocidad de corte y tipo de matriz termoestable. Los cortes con una zona mínima afectada por el calor, de aproximadamente 600 mm y un Ra mínimo de 3.18 μm, se lograron al trabajar con 76 W y 14 mm/s de potencia y velocidad de corte, respectivamente, en el material compuesto de matriz poliéster reforzado con fibra de arroz.

^les^a

The application of plastics reinforced with natural fibers in the industry can be increased using faster and more flexible technologies, such as laser cutting. The anisotropic nature and the degree of combustion of natural fibers in these types of compounds make laser processing very challenging. This study deals with the cutting performance of a low power CO2 laser to cut polymer composite plates (matrix of polyester and epoxy resin) reinforced with natural fibers (Abaca and rice husk) with an average thickness of 3 mm. An experimental DOE design and an Anova analysis of variance were used to determine the significant and influential parameters in the quality of cut and the thermal effect on the material. The processing parameters were the cutting power, cutting speed and type of thermoset matrix. The cuts with a minimum zone affected by heat, of approximately 600 mm and a minimum Ra of 3.18 μm, were achieved by working with 76 W and 14 mm/s of power and cutting speed respectively in the composite material of reinforced polyester matrix with rice fiber.

^len

: .

        · | |     · |     · ( pdf )